Marcato Atlas 150 Pasta Machine Black

Thanks to the MARCATO ATLAS 150 NOODLE MACHINE you can make 1.5 mm thick noodles or pasta. The original MARCATO ATLAS 150 NOODLE MACHINE produced in Italy is 1.5 MM.

The Black Atlas 150 Noodle Machine allows you to easily prepare noodles or pasta for your family in a very short time with the hand-operated side arm or the electric motor you will purchase additionally.

Black Atlas 150 Noodle Machine has been tested and approved not to contaminate your food with any foreign, harmful substances during production.

PREPARING THE MACHINE FOR USE;

Secure the machine using the special vice and place the lever in the hole of the cylinders. When the machine is to be used for the first time, it is necessary to clean it with a dry cloth to remove excess oil. To clean the rollers, pass a small amount of dough between them, which will need to be thrown away later

MIXTURE PREPARATION;

Measurements for 6 people.

Ingredients: 500 gr soft wheat flour and 5 eggs; You can use 1 glass of water instead of 5 eggs. For a delicious pasta, mix 250 grams of soft wheat flour with 250 grams of hard wheat flour. Do not add salt! Put the flour in a bowl and add the eggs to the middle. Mix the eggs with a fork and mix them completely with the flour. Knead the resulting dough with your hands until it reaches a completely homogeneous consistency. If the dough is too hard, add water, if it is too soft, add flour. A dough that is at the right consistency should never stick to your fingers. Take the dough out of the bowl and place it on a lightly floured table. If necessary, continue to knead the dough with your hands and cut it into small pieces. A tip; do not use eggs that have just been taken out of the fridge!

PREPAREDING DOUGH AND PASTA PRODUCED WITH “ATLAS”

Pull the regulator of the machine outwards and bring it to the number 1 so that the two flat cylinders are completely open (approximately 3 mm). By turning the handle, pass a piece of dough between the rollers.

Repeat 5-6 times, doubling the dough and adding flour in the middle if necessary. When the dough takes a regular shape, turn the regulator to number 2 and pass it between the rollers only once. Then pass it through 3 times again until it reaches the desired thickness. (min. thickness – 0.2 mm n..9) Cut the dough with a knife widthwise into lengths of approximately 25 cm (=10) place the arm in the hole of the cutting rollers and while rotating it, pass the dough to obtain the preferred pasta type.

If you wish, you can pass it through the front gear for thin pasta (1.5 mm TAGLIERINI) or through the middle gear for thick pasta (6.5 mm FETTUCCINE)  you can get it.

Note1 – If the rollers ‘cannot cut’ or if they do not separate the dough well, this means that the dough is too soft. In this case, we recommend that you pass the mixture between the flat rollers after adding flour.

Note2 – If the dough is too hard  be careful not to overcook the dough, otherwise the rollers will not be able to take the dough.

Boil plenty of salted water into which you will pour the pasta. (Approximately 4 liters for 1/2 kg of pasta) Fresh pasta cooks in a short time, from 2 to 5 minutes depending on its thickness. Mix carefully and strain after cooking.

MACHINE MAINTENANCE;

1-UsageDuring the process, clean the scrapers under the flat rollers with a piece of kitchen paper from time to time.

2-Never wash the machine with water or in the dishwasher!

3-Use a brush and a wooden stick to clean the machine after use

4-If necessary, a few drop vaseline oil.

5-Do not pass a knife or kitchen cloth between the cylinders.

6-After use, store the machine and its accessories in their own boxes.