Flugel Sharpener Oval 12" Red Handle (5525-810-140)

The handle is plastic and specially designed for right or left-handed users.

There is a special hand protector on the handle for your safety.

Thanks to the specially applied hard chrome layer, it provides even higher wear resistance.

Specially shaped diamond grains allow the blade to be sharpened quickly.

2 million diamond grains are applied to the surface through special processes.

It is made of steel. It has sharp edge features.

The handle part has an ergonomic design and has finger protection for your safety.

The steel is chrome vanadium steel.

The sharpening part is 30 cm 12" in total.

How to Use;

- The cutting edge of the knife should be held between 15°-20° and pulled from the bottom to the tip, without pressing.

Note;

- If the thickness of the sharpening edge, that is, the edge of the knife, is too thick, the edge thickness should be thinned to between 0.4 and 0.6 mm.

- If the knife overheats during sharpening, it changes the structure of the steel, reduces the corrosion resistance and hardness of the knife. For this reason, it may also cause your knife to lose its ability to hold an edge.

- The sharpening process should be applied flawlessly from the bottom to the tip, so that a thin wire cap is formed on the edge of the blade.

- To finish the sharpening work, this thin wire/cap formed on the cutting edge should be removed.

- If the burr formed on the edge is not carefully removed, your blade's cutting sharpness and resistance to dulling can be greatly impaired.

- The blade surface should have a straight cutting line, and a jagged or fragmented edge can cause the blade to break.

- Knives should not be exposed to substances that can cause high corrosion, such as salt water, for too long.